Tire Repair Kit for Car & Moto
Card packing/ sets
Specification:
Tire seal 10cm x 5strips(Dia. 6mm)/ 1pc
Co2 cylinder 16g/ 3pcs
T-handle open eye tool/ 1pc
T-handle screwdriver tool/ 1pc
Plastic adapter/ 1pc
Rubber solution/ 1pc
Small knief/ 1pc
Cover/ 1pc
Bag/ 1pc
Packing:
10 cards/ Inner box
4 Inner boxes/ CTN.
CUFT: 3.1’
N.W.: 18kgs
G.W.: 19kgs
| 1. | Before set up, make sure the switch is in the “closed” position, place the adapter on the inflator. |
| 2. | Smaller hole attach CO2 at the bottom in clockwise direction. |
| 3. | Attach the pipe to the tire and turn the inflator clockwise to insert air into tires with CO2 cylinder. |
| 1. | Pull out the nail from tire. |
| 2. | Clean the injury with the open end inserting tool.Following the direction of the injury and twist. |
| 3. | Times in hole inside. |
| 4. | Feed the seal string to open end inserting tool. Also using a little of solution on the surface of seal string. |
| 5. | Insert the tool by hand into injury through the tire from outside to inside about 1 cm. Then twist it. |
| Put out the tool directly. |