Tire Repair Kit for Car & Moto
Bag packing/ bags
Specification:
Nylon Co2 repair kit bag/ 1pc
Co2 cylinder 16g/ 5pcs
Rubber Solution 7ml/ 1pc
T-handle tire plug tool/ 1pc
T-handle screw drill/ 1pc
Tire seal 10cm x 5strips (4″)/ 1pc
Co2 connection pipe/ 1pc
Steel adapter/ 1pc
Multi-function pliers/ 1pc
Packing:
20 bags/ CTN.
CUFT: 1’
N.W.:14.5kgs
G.W.:15.5kgs


1. | Before set up, make sure the switch is in the “closed” position, place the adapter on the inflator. |
2. | Smaller hole attach CO2 at the bottom in clockwise direction. |
3. | Attach the pipe to the tire and turn the inflator clockwise to insert air into tires with CO2 cylinder. |

1. | Pull out the nail from tire. |
2. | Clean the injury with the open end inserting tool.Following the direction of the injury and twist . |
3. | Times in hole inside. |
4. | Feed the seal string to open end inserting tool. Also using a little of solution on the surface of seal string. |
5. | Insert the tool by hand into injury through the tire from outside to inside about 1 cm. Then twist it. |
Put out the tool directly. |
