Tire Repair Set
Specification:
Rubber Co2 repair kit bag/pc
Co2 cylinder 16g/5pcs
Rubber Solution 7ml/pc
T-handle open eye tool/pc
T-handle screwdriver tool/pc
Tire seal 4”(10cm)/5strips
Co2 connection pipe/pc
Steel adapter/pc
Diagonal pliers/pc
Packing:
20 bags/ CTN.
CUFT: 1’
N.W.: 14.5kgs
G.W.: 15.5kgs
| 1. | Before set up, make sure the switch is in the “closed” position, place the adapter on the inflator. |
| 2. | Smaller hole attach CO2 at the bottom in clockwise direction. |
| 3. | Attach the pipe to the tire and turn the inflator clockwise to insert air into tires with CO2 cylinder. |
| 1. | Pull out the nail from tire. |
| 2. | Clean the injury with the open end inserting tool.Following the direction of the injury and twist . |
| 3. | Times in hole inside. |
| 4. | Feed the seal string to open end inserting tool. Also using a little of solution on the surface of seal string. |
| 5. | Insert the tool by hand into injury through the tire from outside to inside about 1 cm. Then twist it. |
| Put out the tool directly. |