


1. | Before set up, make sure the switch is in the “closed” position, place the adapter on the inflator. |
2. | Smaller hole attach CO2 at the bottom in clockwise direction. |
3. | Attach the pipe to the tire and turn the inflator clockwise to insert air into tires with CO2 cylinder. |

1. | Pull out the nail from tire. |
2. | Clean the injury with the open end inserting tool.Following the direction of the injury and twist. |
3. | Times in hole inside. |
4. | Feed the seal string to open end inserting tool. Also using a little of solution on the surface of seal string. |
5. | Insert the tool by hand into injury through the tire from outside to inside about 1 cm. Then twist it. |
Put out the tool directly. |