| Image |
Title |
Date |
 |
TPK-50 Push-on Valve head for Schrader
1.Before set up, make sure the switch is in the closed position, place the adapter on the inflator.2.Smaller hole attach CO2 at the bottom in clockwise direction.3.Attach the pipe to the tire and turn
|
2025-03-10 |
 |
RS190-06 Rubber Solution
1.Rub off the part to be mended larger then the patch in size.2. Apply slight rubber solution to the part to be mended.3. Slowly take off the foil.4.When the rubber solution dries, paste the patch on
|
2025-03-10 |
 |
TCAR-64 Tire Repair Kit for Car ＆ Moto
1.Pull out the nail from tire. 2. Clean the injury with the open end inserting tool.Following the direction of the injury and twist. 3. Times in hole inside. 4.Feed the seal string to open end inserti
|
2025-03-10 |
 |
SC317-05 RTV Silicone -Blue
1.Remove old gasket material from surfaces thoroughly.2.Clean surface with residue-free solvent and allow surface to dry.3.Cut nozzle to desired size.4.Squeeze tube to form a continuous and even bead
|
2025-03-10 |
 |
SC317-06 RTV Silicone -White
1.Remove old gasket material from surfaces thoroughly.2.Clean surface with residue-free solvent and allow surface to dry.3.Cut nozzle to desired size.4.Squeeze tube to form a continuous and even bead
|
2025-03-10 |
 |
SC317-26 RTV Silicone -White
1.Remove old gasket material from surfaces thoroughly.2.Clean surface with residue-free solvent and allow surface to dry.3.Cut nozzle to desired size.4.Squeeze tube to form a continuous and even bead
|
2025-03-10 |
 |
SC317-31 RTV Silicone -Clear
1.Surface must be clean and dry. Remove all dirt, oil, grease, detergents and loose material.2.Simply remove cap, puncture inner seal, attach nozzle, trim tip and apply by pushing sealant ahead of the
|
2025-03-10 |
 |
SC317-32 RTV Silicone -Red
1.Remove old gasket material from surfaces thoroughly.2.Clean surface with residue-free solvent and allow surface to dry.3.Cut nozzle to desired size.4.Squeeze tube to form a continuous and even bead
|
2025-03-10 |
News